precision is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2026-03-22. Numbers and descriptions here follow the published literature rather than marketing material.
Routine HPLC testing depends on controlled reagents, calibrated instruments, and documented procedures. Columns degrade over time, so retention times and peak shapes are monitored for drift. Mobile phases are filtered and degassed to prevent pump damage and detector noise. Reference standards must be traceable and stored under suitable conditions. Data handling systems record injections, calculations, and audit trails. Quality control samples interspersed with unknowns help detect errors during a run.
Developing an HPLC method begins with defining the purpose, such as quantifying a main component, measuring impurities, or confirming identity. Analysts select separation mode, column, mobile phase, detection, and sample preparation based on analyte properties and matrix. Experiments vary solvent strength, pH, buffer type, and temperature to achieve resolution between critical peaks. The goal is a robust method that produces reliable results across instruments and operators. Method development often involves trial runs and statistical optimization.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
Reversed-phase chromatography dominates modern HPLC testing, using a nonpolar stationary phase such as chemically bonded octadecyl groups and a polar mobile phase of water mixed with organic solvent. Analytes partition between the mobile and stationary phases according to hydrophobicity. Gradient elution changes the mobile phase composition over time to separate compounds with a wide range of retention. Isocratic elution keeps the composition constant and is simpler for routine assays. Column temperature, pH, and flow rate influence selectivity, peak shape, and retention time, so these parameters are controlled during a validated method.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. A diode array detector records full spectra across a wavelength range, which helps identify co-eluting peaks. Mass spectrometry provides mass-to-charge ratios and can confirm molecular identity at low concentrations. The choice of detector depends on analyte structure, required sensitivity, and whether quantitation or identification is the goal. No single detector works for every compound, and method development often compares responses before selecting one.
High-performance liquid chromatography is an analytical technique that separates components of a liquid sample by passing it through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in interaction with the stationary phase cause analytes to migrate at different rates. Detectors record elution as peaks, and a data system converts signals into a chromatogram. The method is suited to compounds that dissolve in a liquid and are not volatile enough for gas chromatography.
| Property | Value | Notes |
|---|---|---|
| Validation parameter | Accuracy | Closeness of measured value to accepted reference value |
| Validation parameter | Precision | Agreement among repeated measurements under specified conditions |
| System suitability check | Resolution ≥ 1.5 | Baseline separation between critical peak pair |
| System suitability check | Tailing factor ≤ 2.0 | Common target for peak symmetry |
| Documentation | Validation report | Summarizes experiments, acceptance criteria, and conclusions |
Detection commonly uses ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. Ultraviolet detection depends on molecular chromophores that absorb light at specific wavelengths. Mass spectrometry provides mass information and sensitive quantification, often after electrospray ionization. Before sample batches, performance checks examine resolution, elution time repeatability, peak symmetry, and plate count. Matrix effects and co-elution remain recognized uncertainties; formal validation studies and orthogonal detection help address them. Detector choice depends on analyte properties and required sensitivity.
High-performance liquid chromatography, or HPLC, separates dissolved compounds by passing a liquid mobile phase through a packed column. Components distribute differently between the stationary phase and the moving liquid, so they travel at different speeds and exit at different times. A detector records these eluting bands as peaks, and peak area or height relates to amount. The technique supports testing in pharmaceuticals, foods, environmental samples, and industrial chemicals. Quantification usually depends on calibration with known standards.
Accumulation of amyloid proteins in the gastrointestinal system may be caused by a wide range of amyloid disorders and have different presentations depending on the degree of organ involvement. Potential symptoms include weight loss, diarrhea, abdominal pain, heartburn (gastrointestinal reflux), and GI bleeding. Amyloidosis may also affect accessory digestive organs including the liver, and may present with jaundice, fatty stool, anorexia, fluid buildup in the abdomen, and spleen enlargement. Accumulation of amyloid proteins in the liver can lead to elevations in serum aminotransferases and alkaline phosphatase, two biomarkers of liver injury, which is seen in about one third of people. Liver enlargement is common. In contrast, spleen enlargement is rare, occurring in 5% of people. Splenic dysfunction, leading to the presence of Howell-Jolly bodies on blood smear, occurs in 24% of people with amyloidosis. Malabsorption is seen in 8.5% of AL amyloidosis and 2.4% of AA amyloidosis. One suggested mechanism for the observed malabsorption is that amyloid deposits in the tips of intestinal villi (fingerlike projections that increase the intestinal area available for absorption of food), begin to erode the functionality of the villi, presenting a sprue-like picture.
Benninghoven graduated from the University of Cologne in 1961 where he worked with Fritz Kirchner (1896–1967) and completed his habilitation in surface physics in Cologne two years later. He first worked as professor in Cologne from 1965 to 1973 until he moved to a full professor position in experimental physics at the University of Münster in 1972. He worked on static secondary ion mass spectrometry (SIMS) and its applications, and developed SIMS instruments. In 1989 he co-founded IonTOF, a company that became a world-leader in TOF-SIMS instrumentation. He has written over 300 scientific articles and several books on the topic of SIMS, many of which have become reference works on SIMS. For his work, he has received the Technology Transfer prize (German Ministry of Education and Research) and the 1984 Gaede-Langmuir Prize (American Vacuum Society) for the development of concepts and instrumentation in static secondary ion mass spectrometry and the demonstration of its usefulness in manifold applications. In 1990 he shared the Fritz-Pregl-Medaille of the Austrian Society of Analytical Chemistry with Wilhelm Simon. From 1977 to 1983, he was president of the German Vacuum Society (part of the German Physical Society).
Antibody Solutions is a privately held American contract research organization headquartered in Santa Clara, California. It provides research and discovery services and fit-for-purpose antibodies to biopharmaceutical and diagnostic companies and academic researchers worldwide. The company’s services include monoclonal and polyclonal antibody and antigen development, molecular modeling, antibody sequencing and engineering, bioreactor technology, pharmacokinetic studies, antibody epitope binning, peptide synthesis, immunoassay development, ligand-binding assay analysis, and support for CAR-T research.
Acta Biochimica et Biophysica Sinica (ABBS) is a peer-reviewed scientific journal which publishes original research articles, short communications, and reviews in the fields of biochemistry and biophysics. Established in 1958, the journal is sponsored by the Institute of Biochemistry and Cell Biology, an institute of the Chinese Academy of Sciences, and is published monthly by Oxford Journals and was published by Blackwell Publishing prior to January 2009. This journal is indexed in the following databases: Science Citation Index Expanded Zoological Record BIOSIS Previews Chemical Abstracts Service – CASSI Index medicus MEDLINE PubMed
Sources: en.wikipedia.org
DHFR has been used as a tool to detect protein–protein interactions in a protein-fragment complementation assay (PCA), using a split-protein approach. DHFR-lacking CHO cells are the most commonly used cell line for the production of recombinant proteins. These cells are transfected with a plasmid carrying the dhfr gene and the gene for the recombinant protein in a single expression system, and then subjected to selective conditions in thymidine-lacking medium. Only the cells with the exogenous DHFR gene along with the gene of interest survive. Supplementation of this medium with methotrexate, a competitive inhibitor of DHFR, can further select for those cells expressing the highest levels of DHFR, and thus, select for the top recombinant protein producers. Dihydrofolate reductase has been shown to interact with GroEL and Mdm2. Click on genes, proteins and metabolites below to link to respective articles.
The Department was founded in 1934 in Kazan Teachers’ Institute to educate future teachers of chemistry. In November, 2011 the Department of Chemical Education became a structural unit of A. M. Butlerov Institute of Chemistry of Kazan (Volga Region) Federal University. Educational research was combined with fundamental and applied research in chemistry. International, All-Russian and regional research-to-practice conferences on chemical education organized by the Department are of the utmost interest. The Department has received letters of gratitude from school principals for instructing students in research and methodology in their preparation for teaching practice. Today 3 Doctors of Science and 5 Doctors of Philosophy are involved in the educational and bringing-up process at the Department. Since 2010 teachers have been retrained in the field of “Teacher of Chemistry”.The head of the Department is Suria I. Gilmanshina, Doctor of Philosophy in Chemistry, Doctor of Science in Education. The Department conducts research in the following fields:
ASQ provides its members with certification, training, publications, conferences, and other services. ASQ is a founding partner of the American Customer Satisfaction Index (ACSI), a quarterly economic indicator. Since 1989, ASQ has administered the annual Malcolm Baldrige National Quality Award. The ASQ also gives the Dorian Shainin Medal, which is awarded annually for the "Development and Application of Creative or Unique Statistical Approaches in the Solving of Problems Relative to the Quality of Product or Service".
Although most yeasts have only a single actin gene, higher eukaryotes, in general, express several isoforms of actin encoded by a family of related genes. Mammals have at least six actin isoforms coded by separate genes, which are divided into three classes – alpha, beta, and gamma – according to their isoelectric points. In general, alpha actins are found in muscle (α-skeletal, α-aortic smooth, α-cardiac), whereas beta and gamma isoforms are prominent in non-muscle cells (β-cytoplasmic, γ1-cytoplasmic, γ2-enteric smooth). Although the amino acid sequences and in vitro properties of the isoforms are highly similar, these isoforms cannot completely substitute for one another in vivo. Plants contains more than 60 actin genes and pseudogenes. The typical actin gene has an approximately 100-nucleotide 5' UTR, a 1200-nucleotide translated region, and a 200-nucleotide 3' UTR. The majority of actin genes are interrupted by introns, with up to six introns in any of 19 well-characterised locations. The high conservation of the family makes actin the favoured model for studies comparing the introns-early and introns-late models of intron evolution.
Many affected infants also have distinctive abnormalities of the head and facial (craniofacial) area. Many of the physical features associated with the disorder are congenital. In most cases, premature closure of fibrous joints (sagittal sutures) between certain bones (parietal bones) of the skull may restrict lateral growth of the skull, causing it to appear abnormally long and narrow that is disproportionate to the body size. In addition, the forehead may be abnormally prominent and the face may be triangular shaped with a hypo plastic mid face, pointed chin. Infants with this disorder may also have abnormally flat cheeks and cheekbones, large ears, prominent mouth with widely spread lips, and or underdeveloped upper jaw bones (maxillary hypoplasia). In addition, in some cases, the teeth may be abnormally crowded together, particularly toward the front of the mouth (anterior crowding) and as a result, the upper result, the upper jaw and lower teeth may not meet properly, they might be abnormally crowded together.
Sources: en.wikipedia.org
It is a set of checks performed before or during an HPLC run to confirm the system works as expected. Parameters may include resolution, tailing factor, theoretical plates, and retention time precision. Failure can trigger maintenance, method adjustment, or repeat analysis.
Validation follows a planned protocol that tests accuracy, precision, specificity, linearity, range, detection limits, quantitation limits, and robustness. Results are compared against predefined acceptance criteria. The validation report supports regulatory filing or routine use.
Revalidation may be needed after changes to column chemistry, mobile phase, detection, sample preparation, or instrument type. It can also follow a pattern of out-of-specification results. The scope depends on whether the change affects method performance.
HPLC testing separates and quantifies components in a liquid sample. It is used to check identity, purity, concentration, or stability. The technique works best for compounds that dissolve and are not easily vaporized.